Dell PowerEdge R720xd User Manual

Browse online or download User Manual for Motherboards Dell PowerEdge R720xd. Dell PowerEdge R720xd Concept Guide

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Dell Processor Acceleration
Technology
Introduction
Dell Processor Acceleration Technology (DPAT), enabled through the BIOS,
provides a better performing solution than turning turbo off to force the
processor to operate at the lowest base frequency, while maintaining a more
consistent turbo frequency state. DPAT minimizes transition duration when the
processor functions in turbo mode, thereby decreasing jitter and allowing for
lesser latency.
The following Dell PowerEdge systems with Intel E5-2690 processors installed,
support DPAT.
.
Enabling DPAT
To enable DPAT on your system, make the following changes in the BIOS setup.
1
Set the required number of cores:
a
Press
<F2>
to enter the
System Setup
menu.
b
In the
Processor Settings
screen, set the
Number of Cores per Processor
to the required value.
NOTE: The maximum turbo frequency increases with fewer cores enabled.
2
Make the required changes in the BIOS
System Profile
using one of the
following methods.
•Set
System Profile
in the BIOS setup to
Performance
mode.
or
PowerEdge System Minimum BIOS Version Minimum iDRAC Firmware Version
R720 1.4.8 1.30.30
R720xd 1.4.8 1.30.30
R620 1.4.8 1.30.30
2013 - 03
Pro.fm Page 9 Tuesday, March 5, 2013 3:27 PM
Page view 0
1 2 3 4

Summary of Contents

Page 1 - Technology

Dell Processor Acceleration Technology IntroductionDell Processor Acceleration Technology (DPAT), enabled through the BIOS, provides a better performi

Page 2 - Session)

• Make the changes using the System Profile Custom selection.•Set System Profile in BIOS to Custom mode.•Set CPU Power Management to Maximum Performan

Page 3 - Disabling Turbo Using WSMAN

Enabling and Disabling DPAT Using WSMANTo enable or disable DPAT using WSMAN, run the following command:winrm i SetAttribute http://schemas.dmtf.org/w

Page 4 - Disabling DPAT Using DTK

Enabling DPAT Using DTKRun the following command to enable DPAT using DTK:Syscfg -controlledturbo=enableDisabling DPAT Using DTKRun the following comm

Comments to this Manuals

No comments