Dell S25V Specifications

Dell Force10 S25 SystemsQuick Start GuideRegulatory Model: S25N/S25V/S25P

8 Installing the Hardware CAUTION: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear an ESD-preventive wrist o

Installing the Hardware 9Installing XFPs CAUTION: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear an ESD-pre

10 Installing the HardwarePower Up SequenceSupply Power and Power Up the SystemThere is no power switch. Supply power to the unit only after it is mou

Installing the Hardware 11S25PThe S25P has two AC power supplies acting in load-sharing mode or can be used independently. Use the power cords shipped

12 Installing the Hardware CAUTION: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear an ESD-preventive wrist

Installing the Hardware 13SpecificationsChassis Physical DesignEnvironmental ParametersParameter S25N/V Specifications S25P SpecificationsHeight 1.73

14 Installing the HardwarePower RequirementsInstalling Power SuppliesThe S25N, S25V, and S25P are shipped with power supplies installed and are not ho

Installing the Software 152Installing the SoftwareNavigating CLI ModesThe FTOS prompt changes to indicate the CLI mode. You must move linearly through

16 Installing the SoftwareStep Task1 Install the RJ-45 copper cable that is shipped with the system into the console port. CAUTION: You must install

Installing the Software 17Accessing the Console PortConnect the RJ-45/DB-9 adapter that is shipped with the S25P system to the RJ-45 cable.3 Set your

18 Installing the SoftwareDefault ConfigurationA version of the Dell Force10 Operating System (FTOS) is pre-loaded onto the chassis, however the syste

Installing the Software 19The S25N, S25V, and S25P systems do not have a dedicated management port, nor a separate management routing able. Configure

20 Installing the SoftwareConfigure a Username and PasswordIn FTOS, you can assign a specific username to limit user access to the system.Configure th

Installing the Software 21Create a VLANThe Default VLAN is part of the system startup configuration, and is by default, VLAN 1. You may make another V

22 Installing the SoftwareAssign an IP address to a VLAN NOTE: An IP address cannot be assigned to the Default VLAN, which, by default, is VLAN 1. To

www.dell.com | support.dell.comPrinted in the U.S.A.

Dell Force10 S25 SystemsQuick Start GuideRegulatory Model: S25N/S25V/S25P

Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indic

About this Guide 3About this GuideThis document is intended as a Quick Start Guide to get new systems up and running and ready for configuration. For

4 About this Guide

Installing the Hardware 51Installing the HardwareThis guide assumes all site preparation has been performed before installing the chassis.Installing t

6 Installing the HardwareStep Task1 Dell Force10 recommends that one person hold the chassis in place while a second person attaches the brackets to t

Installing the Hardware 7Attach a Ground Cable to the System CAUTION: To prevent electrical shock, make sure the switch is grounded properly. If you