Dell 2200F User Manual

support.dell.com Setting Up Host Servers 4-1CHAPTER 4Setting Up Host ServersThis chapter helps you set up and configure host servers attached to the P

4-10 System Administrator’s Guidee. If no icon displays, click Refresh.f. If an icon for the host still does not display, verify the connections of th

support.dell.com Setting Up Host Servers 4-11• During a new installation or a reinstallation of the host operating system, LUNs must be mapped only on

4-12 System Administrator’s Guide

4-2 System Administrator’s GuideInstall the QLogic Fibre Channel Configuration Utility on host servers from the Dell PowerVault Fibre Channel Utilitie

support.dell.com Setting Up Host Servers 4-313. To add a shortcut to your desktop, click Ye s .14. You are prompted to reboot the system. While it is

4-4 System Administrator’s GuideIf all servers carry the same I/O load, calculate the execution throttle value by dividing 480 by the number of server

support.dell.com Setting Up Host Servers 4-56. Press the up- or down-arrow key to highlight the execution throttle value and press <Enter>. The

4-6 System Administrator’s GuideFigure 4-1. Primary Paths and Failover PathsIn Figure 4-1, Server 1 has two adapters, A and B. Server 2 has two adapt

support.dell.com Setting Up Host Servers 4-7Setting Up Primary Failover Paths on a Host ServerNOTE: When using the QLogic Fibre Channel Configuration

4-8 System Administrator’s GuideRegistering Host ServersWhen the dellsanreg.exe — a run-once utility — is run on a host, it sends the PowerVault 530F

support.dell.com Setting Up Host Servers 4-9visible LUNs 0 and assign it to each host you wish to use for remote storage booting. • During the boot pr