Dell KVM 1082DS User Manual download pdf (Page 5)

Mounting and Cable Routing Procedures for Dell™ Digital KVM’s (1082DS, 2162DS, 4322DS)

Page 3



Introduction

This white paper covers recommended mounting and cable routing procedures for Dell™ Digital

KVMs (1082DS, 2162DS, 4322DS) in the following rack enclosures:

 PowerEdge™ 4210

 PowerEdge 2410

 PowerEdge 4820

 PowerEdge 4220

 PowerEdge 2420

The adjustment range for the rails provided with the digital KVMs for third party racks is shown in Table

1. Rail Adjustability Range represents the allowable distance between the outside-facing surfaces of

the front and rear mounting posts of the rack

Table 1: Rail Adjustment Range

 Min(mm) Max(mm)

SquareHole 470 770

RoundHole 456 763

ThreadedHole 462 794

For guidelines on how to route cables within the rack, refer to the Dell

Best Practices Guide for Rack

Enclosure

white paper.

Section 1: 0U Mounting Locations

This section details the locations in the Dell PowerEdge rack enclosures where the KVMs can be

installed, as shipped by Dell™.

Please note the maximum ambient inlet temperature for the digital KVMs is 50 degrees C. In the

event that your rack temperature exceeds this value at the air inlet of the KVM, mount the digital KVM

in front of the rack (Section 2.1). The air inlet for the KVM is located on the non-port side, and the air

exhaust is located on the port side.

Follow the instructions contained in the

Rack Installation Guide

to install the KVM into the 0U bracket.

All illustrations in the following sections were created using a KVM 4322DS, however all the

information is applicable to the 1082DS and 2162DS.

1.1

Supported Locations in the PowerEdge™ 4210 and 2410

The PowerEdge 4210 and 2410 racks support mounting the KVM to the vertical and horizontal

members of the rack. The PowerEdge 4210 supports mounting four digital KVMs on the vertical

members, two on the left side, top and bottom, and two on the right side, top and bottom. The

PowerEdge 4210 also supports mounting two Digital KVMs on the horizontal members, one on the left

side and one on the right side. The PowerEdge 2410 supports mounting two digital KVMs on the

vertical members, one on the left side and one on the right side. The PowerEdge 2410 also supports

mounting two Digital KVMs on the horizontal members, one on the left side and one on the right side.

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Dell KVM 1082DS User Manual Page 5

Comments to this Manuals

Related products and manuals for Computer hardware Dell KVM 1082DS