Dell PowerVault DP600 User Manual download pdf (Page 49)

Changing Resource Groups on Clustered Exchange Servers

A cluster node can have any number of resource groups. Moving a protected data source to a

resource group, between resource groups, or out of a resource group can cause protection job

failures. To successfully make any of those changes to resource group membership, perform the

following steps:

1. Stop existing protection of the data source. The data source could belong to a protection

group as a single data source on a protected server or as a data source as a member of a

resource group.

2. Begin protection of the data source according to its new status, either as a single data source

on a protected server or as a data source as a member of a resource group. This will allocate

a new replica for the data source.

Changing the name of a resource group will affect the protection of all data sources in the

resource group. To change the name of a resource group, perform the following steps:

1. Stop protection of the resource group.

2. Change the name of the resource group.

3. Begin protection of the resource group under its new name.

Recovering Exchange Data

When you select a Microsoft Exchange database for recovery, you can select from the following

recovery options:

• Recover the database to its original location.

This option is available only if you select Latest as the recovery point.

If you select this option, and the recovery destination contains files that have the same

names as the files you are recovering, the current database files will be overwritten during

recovery.

For Exchange 2003 only: You must configure the target database to allow it to be overwritten

by the recovered data. For instructions, see "

How to Configure the Exchange Databases so

That the Restore Process Overwrites Them" (http://go.microsoft.com/fwlink/?LinkId=97929).

• Recover the database to another database on an Exchange 2007 server.

This option is available only for Exchange 2007.

This option is not available if you select Latest as the recovery point. You must specify an

existing database to which the selected database will be recovered. You must configure the

target database to allow it to be overwritten by the recovered data. For instructions, see "

How

to Configure the Exchange Databases so That the Restore Process Overwrites Them"

(http://go.microsoft.com/fwlink/?LinkId=97929).

• Recover to Recovery Storage Group.

This option is available only for Exchange 2007.

This option is not available if you select Latest as the recovery point.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 157 158

No comments

Dell PowerVault DP600 User Manual Page 49