Adding Parts 99
Installing a Floppy Drive
1 Gently slide the drive into place until the tabs securely click into position.
2 Attach the floppy-drive cable to the floppy drive and to the system board
floppy-drive connector.
Ensure that you route the floppy-drive cable through the cable restraint located on the
side of the floppy-drive bay.
3 Attach the floppy-drive power cable to the floppy drive.
4 Check all cable connections and fold cables out of the way to provide airflow for the
fan and cooling vents.
5 Close the computer cover (see page 100).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
6
Connect your computer and devices to electrical outlets, and turn them on.
7 After you turn on your computer, press <F2> when you are prompted to enter
setup mode.
power cable
floppy-drive cable
system board
floppy-drive
connector
cable restraint
Comments to this Manuals