Dell OptiPlex E1 User Manual download pdf (Page 35)

Basic Troubleshooting 2-5

The microprocessor is physically located in a SEPP cartridge/heat sink

assembly on the system board. To reseat the microprocessor, remove the

SEPP cartridge/heat sink assembly and reinstall it as described in “SEPP

Cartridge/Heat Sink Assembly” in Chapter 4.

To reseat a DIMM, remove it from its socket and reinstall it as described in

“DIMMs” in Chapter 4.

If you need to reseat an expansion card, remove it from its connector and

reinstall it as described in “Expansion Cards” in Chapter 4.

For information about these jumpers, see “System Board Jumpers” in

Chapter 1.

Does the problem appear to be resolved?

Yes.

No further steps are necessary. Terminate the procedure.

No.

Proceed to the next sections, “Eliminating Resource Conflicts,” “Run-

ning the System Diagnostics,” and “Getting Help.”

(OLPLQDWLQJ5HVRXUFH&RQIOLFWV

Devices within the computer may require dedicated memory spaces, interrupt

levels, or DMA channels, all of which must be allocated during installation of

the devices. Because a device may be installed at a different time, it is possible

that the same resource is assigned to two or more devices.

Resource conflicts can result in disorderly or erratic system operation or failure

of the system to operate at all. If you suspect that resource conflicts might

exist, check the system and reassign the resources as necessary.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

No comments

Dell OptiPlex E1 User Manual Page 35