Dell PowerEdge M710 User Manual download pdf (Page 9)

Processor Installation 9

Open the grease applicator included with your processor kit and apply

all of the thermal grease in the applicator to the center of the topside

of the new processor.

c Place the heat sink on the processor. See

Figure 1-1

d Close the heat-sink release levers

or replace the screws at the corners

of the heat sink. See your

Hardware Owner’s Manual

for a system-

specific illustration. See Figure 1-1.

Replace the cooling shroud. See "Installing the Cooling Shroud" in the

Hardware Owner’s Manual

Close the system. See "Closing the System" in the

Hardware Owner’s

Manual

Reconnect your system and peripherals to their electrical outlets, and turn

on the system.

Press <F2> to enter the System Setup program, and check that the processor

information

matches the new system configuration. See "Entering the

System Setup Program" in the

Hardware Owner’s Manual

Run the system diagnostics to verify that the new processor operates

correctly.

See "Running the System Diagnostics" in the

Hardware Owner’s Manual

for information about running the diagnostics.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 69 70

No comments

Dell PowerEdge M710 User Manual Page 9