Dell Precision 450 User Manual Page 119

  • Download
  • Add to my manuals
  • Print
  • Page
    / 158
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 118
Installing a CD/DVD Drive
1. If you are installing a new drive, unpack the drive and prepare it for installation.
Check the documentation that accompanied the drive to verify that the drive is configured for your computer. If you are installing an IDE drive, configure
the drive for the cable select setting.
2. Connect the new drive to the set of rails that are attached to the inside of the cover. If a set of rails is not attached inside the computer cover, call Dell.
See Contacting Dell.
3. If you are installing a replacement drive and the new drive does not have the bracket rails attached, remove the rails from the old drive by removing
the two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the screw holes on the drive with the screw holes on
the bracket rails and then inserting and tightening all four screws (two screws on each rail).
4. Gently slide the drive into place until the tabs securely click into position.
1
tab (2)
2
CD/DVD drive
NOTE: A fourth hard drive can be added to a bay using an add-in bay bracket. To order a bracket, see Contacting Dell.
1
drive
2
bracket rails (2)
3
screws (4)
Page view 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 157 158

Comments to this Manuals

No comments