Back to Contents Page
Display
Dell™Inspiron™N3010ServiceManual
Display Assembly
Display Bezel
Display Panel
Display Panel Bracket
Display Cable
Display Hinges
Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the memory-module cover (see Removing the Memory-Module Cover).
4. Remove the memory module(s) (see Removing the Memory Module(s)).
5. Remove the two screws on the bottom of the computer that secure the display assembly to the computer base.
6. Remove the keyboard (see Removing the Keyboard).
7. Remove the palm rest assembly (see Removing the Palm Rest Assembly).
8. Open the display as far as possible.
9. Pull the pull-tab to disconnect the display cable from the connector on the system board.
10. Remove the display cable grounding screw.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
Comments to this Manuals