Dell D1901N monitor User Manual

ModelMUser ManualEnglishDeutschFrançaisItalianoEspañolㅔԧЁ᭛3\FFɤɢɣSvenskaSuomiDanskPolskiNederlands穢剳檺D1901N18.5" wide LCD MonitorModel

8FRONT PANEL CONTROL • Power Button: Press this button to switch ON/OFF of monitor’s power. • Power Indicator: Blue — Power On mode. Orange —

9• To keep the monitor looking new, clean it with a soft cloth. Stubbornstains may be removed with a cloth lightly dampened with a mild detergent s

10 ADJUSTING THE PICTURE The descriptions for function control LEDS Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Description Brightne

11Cool Recall Cool Color Temperature from EEPROM. sRGB Recall SRGB Color Temperature from EEPROM. User-G Green Gain Digital-register. User User-R R

12PLUG AND PLAY Plug & Play DDC2B Feature This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows t

13TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cord

14CLOCK (pixel frequency) controls the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen shows vertical s

15 APPENDIX SPECIFICATIONS Driving system TFT Color LCD LCD Panel Size 470 mm(18.5") Pixel pitch 0.3mm( H ) ×0.3mm ( V ) R,G,B Ana

16 Switch • Power Button • Menu • Image Ratio(+) • ECO/- • Source/Auto External Controls: Functions • Contrast • Brightness • Phase • Clock • H.

17 FACTORY PRESET TIMING TABLE STANDARD RESOLUTIONHORIZONTAL FREQUENCY(kHz) VERTICAL FREQUENCY 640×480 @60Hz 31.469 59.940 VGA 640×480

TABLE OF CONTENTS FOR YOUR SAFETY ----------------------------------------------------------- 1 SAFETY PRECAUTIONS -----------------------

1 Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency

2 PRECAUTIONS • Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. •

3SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. NOTES • Due to the nature of th

INSTALLATION INSTRUCTIONS Install Remove Figure 1 Installing and Removing the Base POWER CORD Power S

CONTROLS AND CONNECTORS SIGNAL CABLE Connecting the Signal Cable: Plug the Signal Cable one end to LCD monitor’s “DSUB-Input” socket , the other end

6ADJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to y

7OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located at front