Dell Compellent Series 40 Setup Guide download pdf (Page 23)

Configuring a System via the Startup Wizard

Step 7: System Setup

The System Setup step allows you to set the System Name and Management IP

Address for the Storage Center.

Figure 11. System Setup

1 Enter the following:

• Enter a System Name for the Storage Center.

• (Dual-controller systems only) Enter the Management IP Address specified in

the pre-installation document. (On single-controller systems, this field is not

displayed and the message at the top of the dialog is slightly different.)

Note The Management IP Address is distinct from the leader and peer controller

addresses. It is the address that manages a clustered-controller system. If the leader

or peer controller fails, the Management IP Address remains valid.

2 Click Continue. The dialog appears allowing you to enable or disable cache.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 69 70

No comments

Dell Compellent Series 40 Setup Guide Page 23