Dell PowerVault NX3200 Owner's Manual download pdf (Page 43)

Figure 12. Removing and Installing a Memory Module

1. memory module

2. memory-module socket ejectors (2)

3. alignment key

6. Install memory-module blanks in vacant memory-module socket(s) to ensure proper system cooling.

7. Install the cooling shroud.

8. Close the system.

9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Installing Memory Modules

WARNING: The memory modules are hot to the touch for some time after the system has been powered down.

Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges

and avoid touching the components on the memory module.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your

warranty. Read and follow the safety instructions that came with the product.

CAUTION: To ensure proper system cooling, memory-module blanks must be installed in any memory socket that is

not occupied. Remove memory-module blanks only if you intend to install memory in those sockets.

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and

peripherals.

2. Open the system.

3. Remove the cooling shroud.

4. Locate the memory-module sockets.

5. Press the ejectors on the memory module socket down and out to allow the memory module to be inserted into the

socket. If a memory module blank is installed in the socket, remove it.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 132 133

No comments

Dell PowerVault NX3200 Owner's Manual Page 43