Dell C7008/C300 Installation Manual download pdf (Page 42)

42 | Powering Up

www.dell.com | support.dell.com

Supplying

WARNING: Never operate the C300 System without a fan tray.

WARNING: The C300 operates in either of two voltage ranges. Each range supports a different supply

configuration. As a safety precaution, do not install more than the recommended maximum number of PSUs

(given by the table below), as this causes high leakage current. Install blank panels in all unused PSU slots.

To supply the C300 system:

To turn off the AC supplies:

• Toggle the switch two the OFF position.

• Unplug the cord from the receptacle on the front of the supply.

• Verify that the LEDs are unlit.

After you supply to the system, the following should occur:

• The fan tray should be operating.

• The green (online) fan tray, RPM, and line card LEDs should be lit and remain lit as long as the system

is receiving and is operational.

When you supply to the C300, the system performs a series of -on self tests. RPM and line card LEDs

blink as the diagnostic programs run. No user interaction is required at this point. Observe the process on

your console monitor. When the boot process is complete, the card LEDs remain online (green) and the

console monitor displays the Command Line Interface (CLI) prompt.

Voltage Frequency Maximum PSU

100 -120 50/60Hz 7 primary + 1 redundant

200 - 240 50/60Hz 7 primary + 1 redundant

Step Task

1 Verify that the source complies with the system input requirements in the section

System Specifications

2 Energize the remote source or outlet.

3 Toggle the switch on the AC supplies to the ON (top) position.

4 In an AC Supply, the LEDs should be green.

If these LEDs are not lit green:

Check that the unit is properly installed.

Verify the source.

If the supply cannot be verified, off all modules and replace the unit.

5 The fan tray LED should be green (online). You should be able to hear the air flowing through the chassis.

If the fans are not operating properly or air is not flowing through the chassis:

off all supplies.

Verify that the fan tray is properly installed.

If the fan tray LED remains unlit, down the unit, and replace the fan tray.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

No comments

Dell C7008/C300 Installation Manual Page 42