Dell Z90DW Installation Guide

Installation GuideDell® Wyse Z Class Conversion to WES7pWyse USB Firmware ToolTM Release 1.20.0.1Products: Z90D7, Z90S7, Z90DE7, Z90DW, Z90SWIssue: 02

6 Chapter 2This page intentionally blank.

3 Installing WES7p FirmwareThis chapter includes the requirements and procedures you need to install and use Wyse USB Firmware Tool to update your thi

8 Chapter 3ProceduresIMPORTANT: Complete the following procedures as an administrator (administrator privileges are required).Step 1: Copy the Z Class

Installing WES7p Firmware 9Figure 8 Configuration options3. Select the Configure the USB key to Copy/Pull or to Update/Push firmware option, and then

10 Chapter 3Figure 10 Browse for image file8. Click Browse.Figure 11 Browse to select commandsXml.xml 9. Navigate to the Z Class WES7p Conversion Im

Installing WES7p Firmware 1111. Select the USB key onto which you want the configurations (you can use Refresh as needed to recognize an inserted USB

12 Chapter 3Step 5: Verifying Thin Client OperationAfter the thin client displays the WES7p desktop, you can verify the Version and that your general

Installing WES7p Firmware 13Step 7: Obtain a Firmware UpdateAfter converting your thin clients, obtain any available firmware update at http://www.wys

Installation GuideDell® Wyse Z Class Conversion to WES7pIssue: 021214Written and published by: Dell Inc., February 2014Created using FrameMaker® and A

Copyright Notices© 2014, Dell Inc. All Rights Reserved.This manual and the software and firmware described in it are copyrighted. You may not reproduc

Contents1 Introduction 1Kit Contents 1Kit Warranty 2Overview 2Dell Technical Support 2Related Documentation and Services 2Dell Online Community 2

iv ContentsThis page intentionally blank.

1 IntroductionThis guide provides step-by-step instructions to use Wyse USB Firmware Tool to convert the following Wyse Z class thin clients to WES7p:

2 Chapter 1· mbr.img· par1.img· par2image1.img· par2image2i.img· vmlinuzKit WarrantyThe warranty on the hardware component of this kit assumes the rem

2 Installing Z Class FlashThis chapter contains information for users of Wyse Z class thin clients who must install new flash. If you are installing f

4 Chapter 24. Place your thumbs on the top surface above where the end screws were removed. With a continuous motion, push firmly downward and towards

Installing Z Class Flash 57. Remove the existing flash module. Locate the flash module and use the Phillips Screwdriver to remove its retaining screw