Dell Networking S5000 User's Guide download pdf (Page 55)

REDIRECT-LIST Mode

You must use REDIRECT-LIST mode to configure a Redirect list on the S5000. For more information, refer to the

S5000

FTOS Command Line Reference Guide

, Policy-based Routing (PBR).

To enter REDIRECT-LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Use the ip redirect-list command. Include a name for the Redirect-list. The prompt changes to include

(conf-redirect-list).

You can return to CONFIGURATION mode by using the exit command.

SPANNING TREE Mode

You must use SPANNING TREE mode to enable and configure the Spanning Tree protocol. For more information, refer to

Spanning Tree Protocol (STP).

To enter SPANNING TREE mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the protocol spanning-tree

stp-id

command.

You can return to CONFIGURATION mode by using the exit command

Per-VLAN SPANNING TREE (PVST+) Plus Mode

You must use PVST+ mode to enable and configure the Per-VLAN Spanning Tree (PVST+) protocol. For more

information, refer to Per-VLAN Spanning Tree Plus (PVST+).

NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.

To enter PVST+ mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the protocol spanning-tree pvst command.

You can return to CONFIGURATION mode by using the exit command.

RAPID SPANNING TREE (RSTP) Mode

You must use RSTP mode to enable and configure RSTP. For more information, refer to Rapid Spanning Tree Protocol

(RSTP).

To enter RSTP mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the protocol spanning-tree rstp command.

You can return to CONFIGURATION mode by using the exit command.

MULTIPLE SPANNING TREE (MSTP) Mode

You must use MULTIPLE SPANNING TREE mode to enable and configure MSTP. For more information, refer to Multiple

Spanning Tree Protocol (MSTP).

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 133 134

No comments

Dell Networking S5000 User's Guide Page 55