Dell Management Plug-in for VMware vCenter 1.7 User Manual download pdf (Page 77)

NOTE: Any deployment jobs that are in progress cannot be aborted.

7. To display the Purge Deployment Job Queue window, click Purge Job Queue. Select the Older than date and job

Status, and click Apply. The select jobs are then cleared from the queue.

Adding A Server Manually

You can manually add a server that has not been added by the discovery process. Once it is added, the server shows up

in the list of servers in the Deployment Wizard.

1. In the Dell Management Center → Deployment, and then click Deployment Wizard.

2. On the Select Server tab, click Add Server.

3. In the Add Server dialog box, do the following:

a) In the iDRAC IP Address text box, enter the iDRAC IP Address.

b) In the User Name text box, enter the user name.

c) In the Password text box, enter the password.

4. Click Add Server. This could take a few minutes.

Removing A Bare Metal Server

You can manually remove a server that has been automatically discovered or manually added.

1. In the Dell Management Center → Deployment click Deployment Wizard.

2. On the Select Servers tab, click Remove Servers.

3. In the Remove Servers dialog box, select the check box of the server to remove.

4. Click Remove Selected Servers.

5. On the Select Servers tab, view the servers listed in the table to confirm it was removed.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 112 113

No comments

Dell Management Plug-in for VMware vCenter 1.7 User Manual Page 77