Dell PowerConnect W-AirWave 7.4 User Manual download pdf (Page 39)

Dell PowerConnect W-AirWave 7.4 | Best Practices Guide CLI ArubaOS and AMP Commands | 39

Ensuring Master Controller Pushes Config to Local Controllers Utilizing

ArubaOS CLI

(Controller-Name) (config) # cfgm mms config disable

(Controller-Name) (config) # write mem

Disable Debugging Utilizing ArubaOS CLI

If you are experiencing performance issues on the Master Controller, ensure that debugging is disabled. It should

be disabled by default. Debugging coupled with gathering the enhanced statistics can put a strain on the

controllers CPU, so it is highly recommended to disable debugging.

To disable debugging, SSH into the controller, enter “enable” mode, and issue the following commands:

(Controller-Name) # show running-config | include logging level debugging

If there is output, then use the following commands to remove the debugging:

(Controller-Name) # configure terminal

Enter Configuration commands, one per line. End with CNTL/Z

(Controller-Name) (config) # no logging level debugging <module from above>

(Controller-Name) (config) # write mem

Restart WMS on Local Controllers Utilizing ArubaOS CLI

To ensure local controllers are populating rogue information properly, SSH into each local controller, enter

“enable” mode, and issue the following commands:

(Controller-Name) # configure terminal

Enter Configuration commands, one per line. End with CNTL/Z

(Controller-Name) (config) # process restart wms

Configure the ArubaOS CLI

Use the following procedure to configure the ArubaOS CLI when not Offloading WMS to AMP (AOS 6.0 and

GT). To ensure proper event correlation for IDS events when WMS if not offloaded to AMP, SSH into each

controller (Master and Local), enter “enable” mode, and issue the following commands:

(Controller-Name) # configure terminal

Enter Configuration commands, one per line. End with CNTL/Z

(Controller-Name) (config) # ids management-profile

(Controller-Name) (config) # ids general-profile <name>

(Controller-Name) (config) # ids-events logs-and-traps

(Controller-Name) (config) # write mem

NOTE: Do not use these commands if using AMP GUI.

NOTE: This command ensures configuration changes made on the master controller will propagate to all local controllers.

NOTE: You will need to wait until the next Rogue Poll Period to execute a Poll Now for each local controller to see rogue devices

begin to appear in AMP after executing restart wms in ArubaOS.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 47 48

No comments

Dell PowerConnect W-AirWave 7.4 User Manual Page 39