Dell™PowerEdge™1800SystemsService-Only Parts Replacement Procedures Before You Begin Recommended Tools Nonredundant Power Supply Power Distrib
Back to Contents Page Dell™PowerEdge™1800SystemsService-Only Parts Replacement Procedures Before You Begin Recommended Tools Nonredundan
9. At the back of the system, remove the two screws that secure the power supply to the system. See Figure1-1. 10. Use the power supply hand
2. Remove the bezel. 3. Open the system: a. Loosen the three thumbscrews on the left-side cover. b. Grasp the cover at both ends and sl
Removing the Control Panel 1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
SCSI Backplane Removing the SCSI Backplane 1. Turn off the system, including any attached peripherals, and disconnect the system from the ele
3. Tighten the SCSI backplane-retention thumbscrew. 4. Replace the drive cage and secure it with the four drive-cage retention screws. 5.
Installing the System Board 1. Holding the system-board tray at an angle, slide the front end of the tray into the chassis. See Figure1-5. Th
Comments to this Manuals