Dell PowerEdge 4600 User Manual download pdf (Page 21)

Utility Partition

The utility partition is a bootable partition on the hard drive that contains system configuration and diagnostic utilities. When implemented, the partition boots

andprovidesanexecutableenvironmentforthepartition's utilities. When the utility partition is not booted, it is designated as a non–MS-DOS®partition.

To start the utility partition, turn on or reboot the system. During POST, the following message appears:

<F10> = Utility Mode

The utility partition provides a text-based interface from which you can run the partition's utilities. To select a menu option, you can either use the arrow keys

to highlight the option and press <Enter> or type the number of the menu option. To exit the utility partition, press <Esc> from the Utility Partition main

menu.

Table2-1 provides a sample list and explanation of the options that appear on the utility partition menu even when the Dell OpenManage Server Assistant CD is

not in the CD-ROM drive. The options displayed on your system may vary depending on the configuration.



Running the System Diagnostics

From the Utility Partition main menu, select Run System Diagnostics. To run the diagnostics from a set of diskettes, create diagnostics diskettes from the Dell

OpenManage Server Assistant CD.

The system hardware diagnostics are described in "Running the System Diagnostics" in your Installation and Troubleshooting Guide.

Asset Tag Utility

The Asset Tag utility allows you to enter an asset tag number for your system.

Using the Asset Tag Utility

To create the Asset Tag utility diskette and boot the system, perform the following steps:

1. If you have not already done so, create a bootable Asset Tag Utility diskette from the Dell OpenManage Server Assistant CD using the Create Diskettes

option.

2. Insert the diskette into the diskette drive and reboot the system.

Assigning and Deleting an Asset Tag Number

An asset tag number can have up to 10 characters. Any combination of characters, excluding spaces, is valid.

To assign or change an asset tag number, perform the following steps:

1. Perform the steps in "Using the Asset Tag Utility."

2. Type asset and a space followed by the new number.

For example, type the following command:

asset 1234567890

3. Press <Enter>.

4. When you are prompted to verify the asset tag number, type y and press <Enter>.

The system then displays the new or modified asset tag number and the service tag number.

To delete the asset tag number without assigning a new one, type asset /d and press <Enter>.

Table2-2 lists the command-line options that you can use with the Asset Tag utility. To use one of these options, type asset and a space followed by the

NOTE: The utility partition provides only limited MS-DOS functionality and cannot be used as a general-purpose MS-DOS partition.

Table 2-1. Utility Partition Main Menu Options

Option

Description

Run System Diagnostics

Runs the system hardware diagnostics.

Run RAID Configuration Utility

Runs the RAID controller configuration utility if a RAID controller card is installed.

NOTE: The options displayed on your system depend on your system configuration and may not include all of those listed here. For the full name of an

abbreviation or acronym used in this table, see the Glossary.

NOTE: The Asset Tag utility works only on systems running MS-DOS.

NOTE: The Asset Tag utility diskette contains CD-ROM drivers that provide access to the CD-ROM drive when you boot from the diskette.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Comments to this Manuals

No comments

Dell PowerEdge 4600 User Manual Page 21

Comments to this Manuals

Related products and manuals for Computer hardware Dell PowerEdge 4600