Dell PowerEdge R300 User Manual download pdf (Page 15)

Four-Post Rack Installation 13

Configuring the Sliding Rail Assemblies (Sliding Rail Kits Only)

The sliding rail assembly has a rotating mounting bracket at each end of the rail. The position of the

bracket determines whether the rail assembly is used as a RapidRail or a VersaRail. The RapidRail side of

the bracket has a hook and a latch that secure it to the vertical rail. The VersaRail side of the bracket has

three holes and uses screws to attach it to the vertical rail.

NOTE: The rack kit ships with the sliding rail assemblies in the RapidRails configuration.

To rotate the mounting bracket and change the mounting rails from RapidRails to VersaRails

(see

Figure 1-5

Lift the release lever on the rotating mounting bracket.

Rotate the bracket and slide it up off the two shoulder standoffs.

Continue to rotate the bracket 180 degrees until you can set the notches back over the shoulder

standoffs.

Rotate the bracket back in the opposite direction on the shoulder standoffs until the bracket clicks

into place.

Figure 1-5. Changing the Position of the Rotating Mounting Bracket

1 rotating bracket 2 release lever 3 shoulder standoffs (2)

4 notches (2) 5 mounting bracket flange

(RapidRails configuration shown)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 201 202

No comments

Dell PowerEdge R300 User Manual Page 15