Dell Dimension 5150__E510 User Manual download pdf (Page 60)

Back to Contents Page

Troubleshooting

Dell™ Dimension™ 5150/E510 Service Manual

Dell Diagnostics

System Lights

Diagnostic Lights

Beep Codes

Dell Diagnostics

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the

Product Information Guide.

NOTE: The Drivers and Utilities CD (ResourceCD) is optional, and as such, may not ship with all computers.

When to Use the Dell Diagnostics

If you experience a problem with your computer, perform the checks in this section and run the Dell Diagnostics before you

contact Dell for technical assistance.

It is recommended that you print these procedures before you begin.

NOTICE: The Dell Diagnostics works only on Dell™ computers.

Enter system setup

to review your computer's configuration information, and ensure that the device you want to test displays

in system setup and is active.

Start the Dell Diagnostics from either your hard drive or from the optional Drivers and Utilities

CD (ResourceCD).

Starting the Dell Diagnostics From Your Hard Drive

1. Turn on (or restart) your computer.

2. When the DELL™ logo appears, press <F12> immediately.

NOTE: If you see a message stating that no diagnostics utility partition has been found, run the Dell Diagnostics from

your (optional) Drivers and Utilities CD.

If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows®

desktop. Then shut down your computer and try again.

3. When the boot device list appears, highlight Boot to Utility Partition and press <Enter>.

4. When the Dell Diagnostics Main Menu appears, select the test you want to run

Starting the Dell Diagnostics From the Optional Drivers and Utilities CD

1. Insert the Drivers and Utilities CD.

2. Shut down and restart the computer.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 71 72

No comments

Dell Dimension 5150__E510 User Manual Page 60