Dell Inspiron 3700 User Manual Page 112

  • Download
  • Add to my manuals
  • Print
  • Page
    / 185
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 111
Memory Modules
Figure 8. Memory Module Removal
To remove a memory module, perform the following steps.
NOTICE: To avoid damaging the system board, remove the power cable, the battery, and the second battery (if installed) before you
service the computer.
1. Remove the memory module cover.
NOTICE: To avoid possible damage to the memory module from electrostatic discharge (ESD), ground yourself by touching the
unpainted metal surface of an I/O connector on the computers back panel.
2. To release a memory module from its socket, carefully spread apart the inner tabs of the memory module socket just far enough for the
memory module to disengage from the socket (it should pop up slightly) (see Figure 8).
3. Lift the memory module out of its socket.
To install a memory module, perform the following steps.
NOTICE: If you only have one memory module, install it in the DIMM A socket. Memory modules are keyed, or designed to fit into their
sockets, in only one direction. The slots on the system board are notched so that the memory module can be firmly seated only one
way.
1. Align the memory modules edge connector with the slot in the center of the memory module socket.
2. With the module at a 45-degree angle, press the memory modules edge connector firmly into the memory module socket.
3. Pivot the memory module down until it clicks into place.
If you do not hear a click as each end of the memory module snaps into the tabs, remove the memory module and reinstall it.
Keyboard Assembly
To remove the keyboard assembly, perform the following steps.
NOTICE: To avoid damaging the system board, remove the power cable, the battery, and the second battery (if installed) before you
service the computer.
NOTICE: Make sure that the work surface is clean to prevent scratching the computer cover.
1. Close the display assembly, and turn the computer upside down on a flat work surface.
Figure 9. Removing the Keyboard Assembly Screws
1
DIMM A
2
DIMM B
3
Memory module sockets (2)
4
Inner tabs (2 per socket)
NOTE: The 192-megabyte (MB) memory modules are designed for either the socket labeled DIMM A or the socket
labeled DIMM B; however, they are not interchangeable. Be sure that the memory module is inserted with the double-
stacked memory chips facing you. A 192-MB memory module inserted with the double-stacked memory chips facing
down does not fit properly in the socket.
Page view 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 184 185

Comments to this Manuals

No comments