Dell Brocade M5424 Quick Start Manual download pdf (Page 7)

M5424 QuickStart Guide 9 of 16

Publication Number: 53-1001081-01

4. Use the appropriate CLI commands to change the IP address of the selected SAN I/O module. Refer to your

Blade Server Enclosure CLI documentation.

Using the CMC GUI to set the IP address

To change the IP address, use the following steps:

1. Open the CMC application’s Setup tab.

2. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate and click Apply.

3. To enable DHCP, select DHCP Enabled and click Apply.

FIGURE 1 CMC Setup Tab

NOTE

Refer to the documentation for the CMC GUI application for additional detail.

Connecting the SAN I/O Module to the Ethernet network

Once you have successfully set the appropriate IP address of the SAN I/O Module, you can establish an Ethernet

connection through the Chassis Management Controller (CMC) to a remote management workstation for any

additional configuration. The management workstation must be on the same Ethernet subnet as the CMC.

NOTE

Ensure that the SAN I/O Module is not being modified from any other connection until configuration is complete.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Dell Brocade M5424 Quick Start Manual Page 7