Dell Lifecycle Controller 1.2 User Manual download pdf (Page 27)

USC and USC - LCE 27

Click

, and then click

to confirm the upload. Allow the process to

complete before you continue to "step 6."

Reboot your system, and then press the

<F10>

key to enter USC - LCE.

Complete the installation of all recommended updates. See "Updating the

Platform using the Platform Update Wizard" for more information.

When updates are complete, your system automatically reboots.

While the system reboots, press the

<F10>

key again to enter

USC - LCE

If a warning message appears on the initial

USC - LCE

screen, you must

repeat "step 7" until the server is in a fully-recovered state.

NOTE: Updates that are required for a complete system recovery are pre-selected

by USC - LCE. Dell highly recommends running all selected updates on your system.

How to Upgrade to an iDRAC6 Express Card

This section provides information about installing an iDRAC6 Express card,

transferring the iDRAC6 Express card from one system to another system,

and Uninstalling iDRAC6 Express card. This hardware upgrade will also

upgrade USC to USC - LCE.

NOTE: This is applicable only on Dell System Series 200-500.

Installing the iDRAC6 Express Card

Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

NOTE: To discharge the residual power in the system, press the

power button once.

Insert the iDRAC6 Express card into the iDRAC6 Express slot.

See the

Hardware Owner’s Manual

for your system for more information

on Installing iDRAC6 Express Card.

LC1_2.book Page 27 Wednesday, November 18, 2009 9:42 AM

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 93 94

No comments

Dell Lifecycle Controller 1.2 User Manual Page 27