Dell PowerEdge R320 User's Guide Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 240
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
28
Hot-swap Hard Drive Carrier
The hot-swap hard drive carrier accepts 15,000-RPM and slower Ultra320 SCSI technology SCA-
type hard drives. The peripheral bay supports Low Voltage Differential (LVD) SCSI disk drives
only. Single-Ended (SE) SCSI devices are not supported in the peripheral bay. SE drives are only
supported on the external SCSI connector. Refer to the Intel
®
Server System SR870BH2 Hardware
and Operating System Validation List for details on tested devices. Contact your Intel
representative to obtain this list.
Hard drive carriers that accommodate 3.5-inch by 1.0-inch SCSI disk drives are required as part of
the hot-swap implementation. The disk drive is attached to the carrier with four fasteners, and is
retained in the chassis by a locking handle. Figure 6 shows a hard drive carrier that has been
removed from the peripheral bay. The drive is accessed by pressing the latch to release the drive
carrier door, then pulling out on the door.
The SCSI backplane board contains a dual-color LED for each hard drive. The LED can be seen at
the right edge of the carrier, as shown in the figure. The LED displays the drive status, as described
in Table 3.
Figure 6. Hard Drive Carrier
Table 3. SCSI Hard Drive LED Details
Feature Description
Green, flashing Indicates the hard drive is active
Yellow/Green flashing Indicates a hard drive fault and hard drive is powered
Yellow/Blank flashing Indicates a hard drive fault and hard drive is not powered
Not illuminated Indicates no hard drive is installed in the bay
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 239 240

Comments to this Manuals

No comments