Dell 530 User Manual download pdf (Page 19)

Memory Riser Board Replacement 19

Installing Memory Riser Boards

NOTICE: System board memory sockets 3 and 4 can either be empty or

contain CRIMMs. Sockets 3 and 4 cannot contain RIMMs with memory riser

boards installed in sockets 1 and 2.

If any RIMMs occupy memory sockets on the system board, remove

those modules.

NOTE: See "Removing a Memory Module."

To locate the memory sockets on the system board, see "System Board

Memory Components."

NOTICE: To avoid damage to the memory riser board, press the riser board

straight down into the socket with equal force applied at each end of the riser

board.

Install memory riser board B (see the following figure):

a Align the slots on the bottom of riser board B with the ridges

inside memory socket 2 on the system board.

The memory sockets on the riser board will face away from the

microprocessor(s).

b Press riser board B straight down into socket 2 until the securing

clips snap into place at the ends of the riser board.

3 Install memory riser board A:

a Align the edges of riser board A with the retention brackets on riser

board B.

b Align the slots on the bottom of riser board A with the ridges

inside memory socket 1 on the system board.

The memory sockets on the riser board will face away from the

microprocessor(s).

c Press riser board A straight down into socket 1 until the securing

clips snap into place at the ends of the riser board.

4 Install the memory riser board retention bracket:

a Lower the bracket to the chassis so that the two bracket tabs insert

into the chassis slots.

b Press the bracket straight down until it is secured in the chassis.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 86 87

No comments

Dell 530 User Manual Page 19