file:///T|/htdocs/SOFTWARE/smusc/smlc/lc_1_4/usclce/en/readme/uscreadme.txt[10/25/2012 1:41:44 PM]
appropriate installation steps to ensure that your operating system
is properly installed to drive letter C:.
If the boot mode is set to UEFI in BIOS (F2 setup) and if you launch
System Services (F10) and Deploy OS, the installation might fail or
you may not be able to boot to the OS after the installation. Always
ensure boot mode is set to BIOS in F2 setup before launching USC and
deploying the OS.
You may see a no optical device found error if you have a bad DVD/CD
in the optical drive. This error does not mean that there are no optical
devices on the system. If you remove the bad media, then this error
will go away.
For RedHat Enterprise Linux version 4.8 operating system, you may need
to install kernel source before installing the drivers present in OEMDRV.
For RAID Configuration, PERC 6.1 Firmware or above is required.
If a floppy drive is attached to the system when the USC is used to
deploy a Windows 2003 Server operating system, error popup messages
will be displayed, and many required device drivers such as NIC, video,
and chipset drivers will not be installed, but the storage device
drivers will be installed. Do not attach floppy devices before
using the USC to deploy a Windows 2003 Server operating system.
If you see this error message "Unable to find a boot device on which
to install the operating system. Verify boot disk availability." and
if you have a USB key plugged in to the system after booting to USC,
please remove the USB key before deploying the operating system.
Note: Account access can be disabled only if there is more than one
user enabled on the iDRAC. To enable users, access the iDRAC Web-based
GUI. Navigate to the Users section under the Network/Security tab and
enable users as needed. Note that at least one more user needs to be
enabled in order to disable the account access in the USC.
During an UEFI based SLES 10 and SLES 11 installation, ensure that no
additional USB or block storage devices are connected to the system.
If there are one, or more USB or block storage devices plugged
into the system, the auto loading of drivers from the embedded storage
fails. This fails because the current implementation of SLES installer
reads only from one USB or block storage device.
If a Non-Dell SD card is attached to the system, the values shown
for "Health" and "Available Space" options are not applicable.
An "Invalid Update Package" error message is displayed, when
- the folder containing the DUP is not accessible.
- the DUP is not present on the USB mass storage device.
- name of the DUP is incorrect.
For an attached Broadcom NetXtreme II 10 Gigabit Ethernet card,
when you change the settings (from the Device Configuration menu)
(1 pages)
(2 pages)
(14 pages)
(46 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals