Dell PowerEdge Rack Enclosure 4210 Installation Manual download pdf (Page 28)

26 Dell™ PowerEdge™ 4210 Installation Guide

Removing the Door Panels From the Optional Door Kit

If you purchase the optional door kit, do the following to remove the door

panels:

Install the doors according to instructions provided in the door kit.

Open the rack doors and locate the panel at the top of each door.

One panel at a time, loosen captive screws on the bottom of the panel.

Grab the sides of the panel and pull up to unseat them from the door.

Repeat steps 3 and 4 on the other door panel.

Coupling Two Racks

CAUTION: Because of the size and weight of the rack cabinets, never attempt to

couple two rack cabinets by yourself.

Unpack and set up both racks.

Unpack the coupling kit, shown in Figure 1-13.

The contents of the rack coupling kit include:

• Four gasket strips

• Four hexagonal spacers

• Eight Allen screws

• A stamped-metal crescent wrench

• A T-handle Allen wrench

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 161 162

No comments

Dell PowerEdge Rack Enclosure 4210 Installation Manual Page 28