Dell POWEREDGE M1000E User Manual download pdf (Page 27)

1-3

Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference

OL-13271-03

Chapter 1 Using the Command-Line Interface

CLI Command Modes

User EXEC Mode

After you access the device, you are automatically in user EXEC command mode. The EXEC commands

available at the user level are a subset of those available at the privileged level. In general, use the user

EXEC commands to temporarily change terminal settings, perform basic tests, and list system

information.

The supported commands can vary depending on the version of software in use. To display a

comprehensive list of commands, enter a question mark (?) at the prompt.

Switch> ?

Privileged EXEC Mode

Because many of the privileged commands configure operating parameters, privileged access should be

password-protected to prevent unauthorized use. The privileged command set includes those commands

contained in user EXEC mode, as well as the configure privileged EXEC command through which you

access the remaining command modes.

If your system administrator has set a password, you are prompted to enter it before being granted access

to privileged EXEC mode. The password does not appear on the screen and is case sensitive.

The privileged EXEC mode prompt is the device name followed by the pound sign (#).

Switch#

Enter the enable command to access privileged EXEC mode:

Switch> enable

Switch#

The supported commands can vary depending on the version of software in use. To display a

comprehensive list of commands, enter a question mark (?) at the prompt.

Switch# ?

To return to user EXEC mode, enter the disable privileged EXEC command.

VLAN

configuration

From privileged EXEC mode,

enter the vlan database

command.

Switch(vlan)#

To exit to privileged EXEC mode,

enter the exit command.

Line configuration From global configuration mode,

specify a line by entering the line

command.

Switch(config-line)#

To exit to global configuration mode,

enter the exit command.

To return to privileged EXEC mode,

enter the end command, or press

Ctrl-Z.

Table 1-1 Command Modes Summary (continued)

Command Mode Access Method Prompt Exit or Access Next Mode

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 107 108

Comments to this Manuals

No comments

Dell POWEREDGE M1000E User Manual Page 27

Comments to this Manuals

Related products and manuals for Computer Accessories Dell POWEREDGE M1000E