Dell POWEREDGE M1000E User Manual download pdf (Page 7)

FC8PT Pass-Through Module 7

Connect the fiber optic cables to the LC connectors on the pass-through

module.

Connect the other end of the cable to the target Fibre Channel device.

3. View Status LEDs

The pass-through module contains several light-

emitting diodes (LEDs). Each port includes a pair of

LEDs (one green and one yellow) that indicate the

status of the ports on the SFP. Power-on self test

(POST) conditions and results are summarized in

Tables 1-1 and 1-2. In addition, at the bottom of the

pass-through module faceplate is an additional pair

of LEDs (one blue and one green) that provide the

status of the pass-through module. Pass-through

module status LEDs are shown in Table 1-3, Pass-

Through Module Status LEDs.

NOTE: For the link rate conditions, there is a one

second pause when the LED is off between each

group of fast blinks (2, 3, or 4). You should observe the LED sequence for several

seconds to ensure that the pause is correctly identified.

50/125 μm (multimode) 500

MHz*km bandwidth cable

300 meters at 2.125 Gb/s

150 meters at 4.25 Gb/s

50 meters at 8.5 Gb/S

.5 meters LC

Table 1-1. Port Status LED – Emulex

Yellow LED Green LED State

Off Off Wake-up failure (dead board)

On Off POST failure (dead board)

Slow blink Off Wake-up failure monitor

Fast blink Off POST failure

Flashing Off POST processing in progress

Off On Failure while functioning

Fiber Optic Cable Maximum Length Minimum

Length

Connector

1 2 3 4 5 6 7 8 9 10 11 12 ... 115 116

No comments

Dell POWEREDGE M1000E User Manual Page 7