72xxx | Local and Remote Configurationxxx
Setup Settings - Port Security
From the serial setup port, you can change the appliance network configuration,
enable debug information, and reset the appliance.
To enable a password to restrict access the serial setup port:
1 From the side navigation bar, select RCS Settings - Ports - Setup to display
the Setup Port Settings page.
2 Click to enable the Enable Setup Port Security box.
3 Enter and confirm your password.
4 Click Save.
Sessions
From the Active Sessions screen, you can view a list of active sessions and the
following information about each session: Target Device, Owner, Remote Host,
Duration, and Type.
Configuring General Sessions
To configure general session settings:
1 From the side navigation bar, select Sessions - General. The General
Session Settings screen appears.
2 Select or deselect the Enable Inactivity Timeout checkbox.
3 In the Inactivity Timeout field, enter the amount of inactive time you want
to pass before the session closes (from 1 to 90 minutes).
4 In the Login Timeout field, enter the amount of inactive time you want to
pass before you must log in again (from 21 to 120 seconds).
5 Select or deselect the Enable Preemption Timeout checkbox.
Comments to this Manuals