Dell PowerVault 56F (16P Fibre Channel Switch) User Manual download pdf (Page 32)

4-8 Dell PowerVault 5xF Switches Zoning Guide



This section discusses the configuration management commands, which allow you to

configure the zones.

 *

The following example shows the cfgSave command, which writes a copy of the

defined configuration

and the name of the effective configuration to flash memory in

all fabric switches:

The saved configuration is automatically reloaded by the switch at system start-up. If

a configuration was in effect when it was saved, the same configuration is reinstated

with an automatic cfgEnable command.

NOTE: Dell recommends saving after you enable and test a configuration. Any

unsaved configuration will be lost if the system fails.

 -'

The following example shows the cfgEnable command, which enables a specified

configuration:

 +'

The following example shows the cfgDisable command, which disables the current

zone configuration:

The fabric returns to a non-zoned mode, in which all devices see each other.

!'%

1!.

!'&!#1%$#

!!#1%$#!

!'+#1%$#

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38

No comments

Dell PowerVault 56F (16P Fibre Channel Switch) User Manual Page 32