Dell UPS 500T User Manual download pdf (Page 19)

Dell UPS Management Software: Common Software Installation Scenarios

Enable Redundant UPS Support in ULNM: To turn on the support for redundant UPS configurations:

System  Edit Modules Settings  Check “Redundancy”

Figure 20: Enabling Redundancy in ULNM

Connecting to the Dell UPSs: The Dell UPS(s) will automatically appear in the “Auto Discovery” menu

within ULNM. This polling can take a few minutes. If the UPS does not appear (or to proceed more

quickly), perform a “Range Scan” and enter the IP addresses of the Dell UPS Network Cards: “Auto

Discovery”  “Range Scan”  Create new range for the IP address of the Dell UPS.

Figure 21: ULNM range scan

To set the access parameters for each Dell UPS: right click each UPS device and choose “Set Node

Access Parameters” (default is admin/admin).

Figure 22: Set node access parameters

Figure 23: Access parameters

To create a redundant composite UPS device: Select the 2 (or more) Dell UPSs you wish to use in

redundant configuration by Ctrl + Click the devices. Right click and choose “Set Composite Device”.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Dell UPS 500T User Manual Page 19