Dell OptiPlex E1 User Manual download pdf (Page 36)

SEPP Cartridge/Heat Sink Assembly Removal (Low-ProfileChassis):Dell™OptiPlex™E1

Systems



To remove the SEPP cartridge/heat sink assembly, follow these steps:

1. Remove the system power supply.

2. Locate the SEPP cartridge/heat sink assembly.

3. Disconnect the microprocessor fan connector from the 3-pin connector (labeled "FAN") on the system board, located between the SERIAL2 connector and the

MONITOR connector.

The connector is located between the SERIAL 2 connector and the MONITOR connector.

4. Locate and press outward on the SEPP cartridge release latches (located directly on top of the SEPP cartridge adjacent to the heat sink assembly).

5. Lift the SEPP cartridge/heat sink assembly out of its guide bracket assembly/connector on the system board.

WARNING: The SEPP cartridge/heat sink assembly can get extremely hot during system operations. Be sure that the assembly has had

sufficient time to cool before touching it.

NOTE: When installing the SEPP cartridge/heat sink assembly, carefully orient the assembly and press firmly with up to 25 pounds of force to connect

the SEPP cartridge with its connector.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 74 75

Comments to this Manuals

No comments

Dell OptiPlex E1 User Manual Page 36

Comments to this Manuals

Related products and manuals for Computers Dell OptiPlex E1