Dell OptiPlex GX400 User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
Installing a Memory Module
1. Press the securing clips at each end of the socket outward until they snap open (see the following figure).
Installing a Memory Module
2. Align the slots on the bottom of the module with the two ridges inside the socket.
3. Press the module straight down into the socket until the securing clips snap into place at the ends of the module.
Disk Drives and Media
Installing a CD, ZIP, or Other Externally Accessible Drive
in the Chassis
1. Turn off the computer and peripherals, disconnect them from their electrical outlets, wait at least 5 seconds, and then remove the computer cover.
2. Rotate the power supply away from the system board.
3. Remove the front panel.
4. Remove the drive bracket from the chassis drive bay you want to use.
Squeeze together the metal tabs that extend from each side of the drive bracket, and pull the bracket out of the bay (see the following figure).
Removing the Drive Bracket
If a drive is already installed in the bay and you are replacing it, disconnect the DC power cable and interface cable from the back of the drive before
removing the bracket from the bay. To remove the old drive from the bracket, turn the drive/bracket assembly upside down and remove the four screws
that secure the drive to the bracket (see "Attaching the Drive Bracket to the New Drive").
5. Unpack the drive and prepare it for installation.
See the documentation that accompanied the drive to verify that the drive is configured for your computer. Change any settings necessary for your
CAUTION: Before you perform this procedure, see "Safety First For You and Your Computer."
NOTICE: Ground yourself by touching an unpainted metal surface on the back of the computer.
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

Comments to this Manuals

No comments