Dell 5130cn Service Manual download pdf (Page 75)

6 – 6

Chapter 6 Principles of Operation

Finisher Service Manual

Version 1 2009.03.31

2.5 Feeding in Compile Tray

While the GUIDE PAPER 240 (PL 14.5.38) slides out toward the Stacker Tray, driven by the MOTOR

ASSY EJECT (PL 14.5.6), the ROLLER ASSY EJECT PINCH (PL 14.6.3) retracts upward to allow the

sheet to come in from the X' port.

The sheet coming in from the X' port falls onto the Compile Tray.

When stapling or tamping is not specified, the ROLLER ASSY EJECT PINCH lowers to allow the sheet

to exit to the Stacker Tray. (Refer to 2.6 Ejection to Stacker Tray.)

When stapling or tamping is specified, the ARM ASSY PADDLE (PL 14.6.4) lowered by the SOLENOID

ASSY (PL 14.6.20), upon the falling of the sheet onto the Compile Tray.

Then, the PADDLE SUB (PL 14.6.8) of the ARM ASSY PADDLE and the Main Paddle of the SHAFT

ASSY MAIN PADDLE (PL 14.7.13) rotate driven by the DRIVE ASSY TRANS (PL 14.7.6), to slide the

sheet backward (reverse to the exit direction) until it stops against the flange of the Compile Tray.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 135 136

No comments

Dell 5130cn Service Manual Page 75