Dell DX6004S User Manual download pdf (Page 103)

Installing System Components 103

Reconnect the system to its electrical outlet and turn the system on,

including any attached peripherals.

Start up the system, press <F2> to enter the System Setup program, and

check the

System Memory

setting on the main System Setup screen.

The system should have already changed the value to reflect the newly

installed memory.

If the value is incorrect, one or more of the memory modules may not be

installed properly. Repeat step 2 through step 13 of this procedure, checking to

ensure that the memory modules are firmly seated in their sockets.

Run the system memory test in the system diagnostics. See "Running the

Embedded System Diagnostics" on page 154.

Removing Memory Modules

WARNING: The memory modules are hot to touch for some time after the system has

been powered down. Allow time for the memory modules to cool before handling

them. Handle the memory modules by the card edges and avoid touching the

components on the memory module.

CAUTION: Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your product

documentation, or as directed by the online or telephone service and support team.

Damage due to servicing that is not authorized by Dell is not covered by your warranty.

Read and follow the safety instructions that came with the product.

Turn off the system, including any attached peripherals, and disconnect the

system from the electrical outlet.

Open the system. See "Opening the System" on page 76.

Remove the

cooling shroud

. See "Removing the Cooling Shroud" on page 93.

Locate the memory module sockets. See

Figure 6-1

Press down and out on the ejectors on each end of the socket until the memory

module pops out of the socket. See Figure 3-12.

Handle each memory module only on either card edge, making sure not to

touch the middle of the memory module.

Replace the

cooling shroud

. See "Installing the Cooling Shroud" on page 95.

Close the system. See "Closing the System" on page 77.

Reconnect the system to its electrical outlet and turn the system on, including

any attached peripherals.

book.book.book Page 103 Tuesday, September 7, 2010 8:45 PM

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 167 168

Comments to this Manuals

No comments

Dell DX6004S User Manual Page 103

Comments to this Manuals

Related products and manuals for Hardware Dell DX6004S