Dell DX6004S User Manual Page 80

  • Download
  • Add to my manuals
  • Print
  • Page
    / 168
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 79
80 Installing System Components
Installing an Optical Drive
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 If applicable, remove the front bezel. See
"Front Bezel (Optional)" on
page 75.
2
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
3
Open the system. See "Opening the System" on page 76.
4
Align the two notches on the metal standoffs with the slots on the side of
the drive.
5
Slide the drive into the notches until it is seated firmly and the release
latch snaps into place. See Figure 3-4.
6
Connect the power cable.
7
Connect the data cable to the back of the drive and to the SATA connector
on the system board.
NOTE: Route these cables properly underneath the tab on the system chassis
to prevent them from being pinched or crimped.
8
Close the system. See "Closing the System" on page 77.
9
If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 75.
10
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
book.book.book Page 80 Tuesday, September 7, 2010 8:45 PM
Page view 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 167 168

Comments to this Manuals

No comments