output (I/O) panel on the back of the computer.
● A part can be replaced by performing the removal procedure in reverse order.
● The computer is undocked from the advanced port replicator (APR).
When the display assembly is open nearly 180 degrees, use a book or something similar to support it. The angle of
the display assembly with respect to the bottom case should never be allowed to exceed 180 degrees. Also, when
performing the procedures in this document, the locations or directions relative to the computer are as shown in
Figure 1 unless otherwise specified.
Figure 1. Computer Orientation
Recommended Tools
Most of the procedures in this document require the use of one or more of the following tools:
● # 1 magnetized Phillips-head screwdriver
● Small flat-blade screwdriver
● Small plastic scribe
● Processor extractor
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LAP...Inspiron/3700/3700%20System%20Reference/r_r.htm (2 of 30)6/21/2004 12:52:05 AM
Comments to this Manuals