Dell Inspiron 3800 User Manual download pdf (Page 56)



To remove the display assembly bezel, perform the following steps.

NOTICE: To avoid damaging the system board, remove the power cable, the battery, and the second

battery (if installed) before you service the computer.

1. Use a scribe to carefully pry the four rubber screw covers out of the four screw holes located at the top of the

bezel on the front of the display assembly.

2. Remove the four 4-mm screws located at the top of the bezel on the front of the display assembly (see Figure

14).

3. Use a scribe to carefully pry the two plastic screw covers out of the two screw holes located at the bottom of

the bezel on the front of the display assembly.

4. Remove the two 4-mm screws from the bottom of the bezel.

NOTICE: The bezel tabs are fragile. Handle the bezel carefully to avoid breaking the tabs off.

5. Separate the bezel from the display-assembly top cover.

The bezel is secured by three tabs on the left and right side of the display-assembly top cover.

Display assembly

bezel

Hinge cover

Latch

LCD panel

3-mm screws (6)

Plastic screw covers (2)

Display-assembly top

cover

4-mm screws (6)

LCD flex cable

Rubber screw covers (4)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 92 93

No comments

Dell Inspiron 3800 User Manual Page 56