Dell E2414H Monitor User Manual download pdf (Page 10)

18  Setting Up the Monitor Setting Up the Monitor  19

Setting Up the Monitor

Attaching the Stand

NOTE: The stand is detached from monitor when it is shipped from the

factory.

NOTE: This is applicable for a monitor with a stand. When any other

stand is bought, please refer to the respective stand setup guide for set

up instructions.

To attach the monitor stand:

1. Remove the cover and place the monitor on it.

2. Fit the two tabs on the upper part of the stand to the groove on the

back of the monitor.

3. Press the stand till it snaps into its place.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section,

follow the Safety Instructions.

To connect your monitor to the computer:

1. Turn o your computer anddisconnect the power cable.

2. Connect either the white (digital DVI-D) (E2414H only) or the blue

(analog VGA) display connector cable to the corresponding video

port on the back of your computer.Do not connect both cables

on the same computer. Use both the cables only when they are

connected to two dierent computers with appropriate video

systems.

Connecting the White DVI Cable (E2414H only)

Connecting the Blue VGA Cable

CAUTION: The graphics are used for the purpose of illustration only.

Appearance of the computer may vary.

Organizing the Cables

After attaching all necessary cables to your monitor and computer, (See

Connecting Your Monitor for cable attachment,) use the cable management

slot toorganize all cables as shown above.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

No comments

Dell E2414H Monitor User Manual Page 10