Dell PowerConnect 8164F User's Guide download pdf (Page 9)

Deploying the Dell PowerConnect 8100 with the Cisco Catalyst

VLAN configuration example

The following topology overview is an example of a much abbreviated network configuration between

two (2) end-user systems, the campus switch, and the core.

Example of access, and trunk VLANs

Figure 6.

Dell PowerConnect 8100 CLI

Run the commands below on the Dell PowerConnect 8100 switch to create an access mode switchport

going to a client (or edge) device. Then create a 2-port LACP LAG with a trunk mode switchport

carrying VLANs between it and the Cisco Catalyst 6504.

console#configure

console(config)#vlan 100, 101

console(config-vlan)#exit

console(config)#interface te1/0/1

console(config-if-Te1/0/1)#switchport access vlan 100

console(config-if-Te1/0/1)#exit

console(config)#interface te1/0/2

console(config-if-Te1/0/1)#switchport access vlan 101

console(config-if-Te1/0/1)#exit

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Dell PowerConnect 8164F User's Guide Page 9