Dell S50V-FTOS-PoE Specifications

Dell Force10S50N and S50V SystemsQuick Start GuideRegulatory Model: S50N/S50V

8 Installing the Hardware CAUTION: You can insert and connect XFP transceivers while the switch is operating. You can also disconnect and remove XFP

Installing the Hardware 9• All protective covers are in place.• Blank panels are installed if optional modules are not installed. NOTE: A US AC power

10 Installing the HardwarePower SuppliesOn both the S50N and S50V, either the AC or DC power supplies alone are sufficient to power the switch. When b

Installing the Hardware 11Environmental ParametersAC Power RequirementsParameter S50N and S50N-DC SpecificationsS50V SpecificationsTemperature Operati

12 Installing the HardwareDC Power RequirementsInstalling Power SuppliesThe S50N and the S50V are shipped with power supplies installed and are not ho

Installing the Software 132Installing the SoftwareNavigating CLI ModesThe FTOS prompt changes to indicate the CLI mode. You must move linearly through

14 Installing the SoftwareAccessing the Console PortConnect the RJ-45/DB-9 adapter that is shipped with the S50V system to the RJ-45 cable.Step Task1

Installing the Software 15Default ConfigurationA version of FTOS is pre-loaded onto the chassis, however the system is not configured when you power u

16 Installing the Software• Characters within the string can be letters, digits, and hyphens.Access the System RemotelyYou can configure the system to

Installing the Software 17Configure the Enable PasswordThe EXEC Privilege mode is accessed by the enable command. Configure a password as a basic secu

18 Installing the SoftwareAssign Interfaces to a VLANA port may either be an untagged member of a single VLAN, or a tagged member of perhaps multiple

Installing the Software 19Connecting the Chassis to the NetworkOnce you have completed the hardware installation and software configuration, you can c

20 Installing the Software

www.dell.com | support.dell.comPrinted in the U.S.A.

Dell Force10S50N and S50V SystemsQuick Start GuideRegulatory Model: S50N/S50V

Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indic

About this Guide 3About this GuideThis document is intended as a Quick Start Guide to get new systems up and running and ready for configuration. For

4 About this Guide

Installing the Hardware 51Installing the HardwareThis guide assumes all site preparation has been performed before installing the chassis. Installing

6 Installing the HardwareAttach a Ground Cable to the S50N and S50V ChassisThe S50V and S50N switches have both AC (3-prong plug receptacle) and DC (-

Installing the Hardware 7You must provide your own cables to connect to the power source. Cables must be sized for 11.5 A service at no more than -48V