Dell PowerConnect 8100 Series User Manual

Dell PowerConnect 8100 Series Switch Configuration Guide Dell Storage Engineering February 2013 [email protected]

10 SCG1001 PowerConnect 8100 Series Configuration Guide 3 Configure Data Center Bridging (DCB) (Optional) DCB is enabled by default. This sectio

11 SCG1001 PowerConnect 8100 Series Configuration Guide console(config-if)#exit console(config)#interface range fortygigabitethernet 1/1/1-2 cons

12 SCG1001 PowerConnect 8100 Series Configuration Guide 4 Reverting from DCB to non-DCB configuration (Optional) One method to revert from a DCB

13 SCG1001 PowerConnect 8100 Series Configuration Guide console(config-if-dcb)#exit console(config-if)#exit 4.2 Revert to default VLAN ID on swit

14 SCG1001 PowerConnect 8100 Series Configuration Guide 4.4 Configure additional switch Repeat the commands from section 4 to disable DCB on any

15 SCG1001 PowerConnect 8100 Series Configuration Guide Additional resources Support.dell.com is focused on meeting your needs with proven service

This white paper is for informational purposes only. The content is provided as is, without express or implied warranties of any kind

2 SCG1001 PowerConnect 8100 Series Configuration Guide © 2013 Dell Inc. All rights reserved. Reproduction of this material in a

3 SCG1001 PowerConnect 8100 Series Configuration Guide Table of contents 1 Introduction ...

4 SCG1001 PowerConnect 8100 Series Configuration Guide 1 Introduction This document illustrates how to configure Dell™ PowerConnect™ 8100 Series

5 SCG1001 PowerConnect 8100 Series Configuration Guide 1.3 Cabling diagram The cabling diagram shown below represents the Dell recommend method f

6 SCG1001 PowerConnect 8100 Series Configuration Guide 2 Dell recommended switch configuration These steps show you how to configure two PowerCon

7 SCG1001 PowerConnect 8100 Series Configuration Guide Enter Choice# 10 Are sure you want to Erase Current Configuration? (Y/N): Y Enter Choice# 9

8 SCG1001 PowerConnect 8100 Series Configuration Guide • Disables unicast storm. • Enables spanning tree portfast on ports connected to EqualLog

9 SCG1001 PowerConnect 8100 Series Configuration Guide 2.9 Configure port channel for LAG These commands configure the switch interconnect as a L