Dell PowerEdge M IO Aggregator Quick Start Guide download pdf (Page 19)

7. By default, the IP address and subnet mask of the out-of-band management interface used for

remote SNMP or Telnet access is assigned by a DHCP server. You can reconfigure the default setting

by specifying an IP address with the following commands:

interface ManagementEthernet slot/port, where slot is 0 and port is 0.

ip address ip-address/mask, where ip-address is in dotted-decimal format (A.B.C.D) and

mask is a subnet mask in /prefix-length format (/xx).

no shutdown enables the interface.

Dell(conf)# interface ManagementEthernet 0/0

Dell(conf-if-ma-0/0)# ip address 128.0.0.1/24

Dell(conf-if-ma-0/0)# no shutdown

8. To reconfigure the default route used by the out-of-band interface to access the aggregator from a

remote network, enter the management route subnet/mask managementethernet command,

where the subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a subnet mask that

defines the out-of-band management network:

Aggregator1(conf)#management route 10.0.0.0/16 128.0.0.5

9. By default, the IP address of the default VLAN used to access the switch from an in-band routing

interface is assigned by a DHCP server. You can reconfigure the default setting by specifying an IP

address with the ip address ip-address/mask command:

Dell(conf)# interface vlan 1

Dell(conf-if-vl-1)# ip address 10.1.1.4/24

10. To reconfigure the default route used by the in-band management interface (default VLAN) used to

access the aggregator from a remote network, enter the ip route subnet/mask vlan 1

command, where the subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a

subnet mask that defines the in-band management network:

Dell(conf)# ip route 10.1.1.0/24 vlan 1

11. By default, broadcast storm control is enabled on the aggregator to limit unregistered unicast,

multicast, and broadcast packets. To disable storm control, enter the no io-aggregator

broadcast storm-control

command:

Dell(conf)# no io-aggregator broadcast storm-control

12. By default, IGMP multicast flooding is enabled on the aggregator. To disable multicast flooding to

send unregistered multicast packets only to interested hosts in a VLAN, enter the no ip igmp

snooping flood command:

Dell(conf)# no ip igmp snooping flood

13. To verify the reconfigured settings, enter the show running-config command:

Dell# show running-config

14. To save the reconfigured settings to the startup configuration, enter the write memory command:

Dell# write memory

For more information about aggregator configuration, refer to the Dell Networking Configuration Guide

for the Dell PowerEdge FN 410S I/O Aggregator.

Aggregator Auto-Configuration

After the aggregator powers on, it auto-configures and is operational with the following software features

enabled:

• VLANs: In Standalone mode, all ports are configured as members of all (4094) VLANs. All VLANs are

up and can send or receive Layer 2 traffic.

For more information, refer to Configuring VLANs.

• Data center bridging capability exchange protocol (DCBX).

• Fiber Channel over Ethernet (FCoE) connectivity.

Installing and Configuring the Aggregator

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

Comments to this Manuals

No comments

Dell PowerEdge M IO Aggregator Quick Start Guide Page 19

Comments to this Manuals

Related products and manuals for Networking Dell PowerEdge M IO Aggregator