1. Align the control panel assembly's mounting holes with the chassis mounting holes. See Figure7-1.
2. Using a #2 Phillips screwdriver, install the two screws that secure the control panel assembly to the chassis. See Figure7-1.
3. Connect the control panel cables. See Figure7-1.
4. Close the system. See "Closing the System" in "Troubleshooting Your System."
Daughter Card
Removing the Daughter Card
1. Open the system. See "Opening the System" in "Troubleshooting Your System."
2. Disconnect the SATA, control panel, and optical drive cables, and disconnect the PCI fan cable if present. See Figure7-2.
3. Using a #2 Phillips screwdriver, remove the screw that secures the daughter card to the chassis. See Figure7-2.
4. Slide the daughter card away from the connector on the edge of the system board and remove it from the system.
Figure 7-2. Removing the Daughter Card
Installing the Daughter Card
1. Slide the daughter card into the connector on the edge of the system board. See Figure7-2.
2. Using a #2 Phillips screwdriver, install the screw that secures the daughter card to the chassis. See Figure7-2.
3. Connect the optical drive, control panel, and SATA cables, and connect the PCI fan cable if applicable. See Figure7-2.
4. Close the system. See "Closing the System" in "Troubleshooting Your System."
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer and protecting against electrostatic discharge.
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer and protecting against electrostatic discharge.
Comments to this Manuals