4. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Diskette Drive
Removing a Diskette Drive
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."
3. Lay the system on its right side.
4. Remove the cover. See "Removing the Cover" in "Troubleshooting Your System."
5. Disconnect the power cable and the interface cable from the diskette drive. See Figure7-2.
6. Remove the two screws that secure the diskette drive in the externally accessible drive bay. See Figure7-2.
7. Slide the diskette drive forward out of the drive bay.
Installing a Diskette Drive
1. Unpack the drive and prepare the drive for installation.
For instructions, see the documentation that accompanied the drive.
2. Slide the diskette drive into the externally accessible drive bay.
3. Install the two screws that secure the diskette drive in the drive bay. See Figure7-2.
4. Connect the power cable and the interface cable to the diskette drive. See Figure7-2.
5. Install the cover. See "Replacing the Cover" in "Troubleshooting Your System."
6. Stand the system upright.
7. Install the bezel. See "Installing the Bezel" in "Troubleshooting Your System."
8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 7-2. Removing or Installing a Diskette Drive
Comments to this Manuals