Dell Studio 1735 Specifications download pdf (Page 15)

Back to Contents Page

 Processor

Dell™Studio1735/1737ServiceManual

Removing the Processor

Installing the Processor



Removing the Processor



1. Follow the instructions in Before You Begin.



2. Turn the computer over and remove the base cover (see Removing the Base Cover).



3. Remove the processor heat sink (see Removing the Processor Heat Sink).



4. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.

The ZIF-socket cam screw secures the processor to the system board. Take note of the arrow on the ZIF-socket cam screw.



5. Use a processor extraction tool to remove the processor.

Installing the Processor



CAUTION: Before working inside your computer, follow the safety instructions that shipped with your computer.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface

(such as a connector on the back of the computer).

NOTICE: To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press

to apply slight pressure to the center of the processor while turning the cam screw.

NOTICE: To avoid damage to the processor, hold the screwdriver such that it is perpendicular to the processor when turning the cam screw.

NOTICE: When removing the processor, pull it straight up. Be careful not to bend the pins on the processor.

NOTICE: To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press

to apply slight pressure to the center of the processor while turning the cam screw.

processor

pin-1 corner of processor

ZIF socket

ZIF-socket cam screw



1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 46 47

No comments

Dell Studio 1735 Specifications Page 15