Dell TL1000 User's Guide Page 133
- Page / 194
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Appendix A. Error codes
“Library error codes”
“Drive error codes” on page A-11
“Web User Interface error messages” on page A-11
“Trap definitions (types)” on page A-14
When an error occurs during operation of the library, the library stops the current
operation and displays an error code on the Operator Panel. Unless otherwise
noted, try to resolve the problem by cycling power to the library and retrying the
last operation.
Note: When power cycling the library, wait 10 seconds after the power is switched
OFF before powering ON again.
Library error codes
Table A-1. Library error codes
Code (H) Description Panel Indication Action Required
0000 No valid error code information. -
0001
At power-on initialization, a
firmware error was detected.
All4LEDsON
1. Upgrade/reinstall firmware and try again.
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
Dell technical support” on page 7-2.
0002
At power-on initialization, a RAM
(base area) error was detected.
Ready/Activity
LED ON and
Error LED ON
0003
At power-on initialization, a RAM
(buffer area) error was detected.
CHK 0003
0008
A usable drive could not be
detected.
CHK 0008
1. Observe LEDs. See “Interpreting front panel
LEDs” on page 6-8.
2. Reseat all cables. See “Reseating cables” on
page 6-10.
3. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
Dell technical support” on page 7-2.
0009
The accessor locking screw has
not been removed.
CHK 0009
1. Remove the accessor locking screws. See
“Removing the accessor locking screw” on
page 3-7.
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
Dell technical support” on page 7-2.
A-1
- User's Guide 1
- Read this first 5
- Contents 7
- Safety notices 13
- Laser safety and compliance 14
- Rack safety 15
- CAUTION: 16
- PowerVault 17
- TL1000 Tape Library 17
- Front panel 20
- Cartridge magazine 22
- Rear panel 23
- Bar code reader 24
- SAS host interface 24
- Encryption 24
- Supported Internet Protocols 25
- Network Time Protocol 25
- Ultrium tape drives 26
- Library specifications 28
- Product environment 29
- Supported device drivers 30
- Chapter 2. User interfaces 31
- Front panel LEDs 33
- Input modes 33
- Selecting predefined values 33
- Toggling values 33
- Entering numerical values 34
- Logging in 34
- Web User Interface 35
- Common header elements 36
- User privileges 38
- Choosing a location 39
- Installing in a rack 40
- Connecting the power cord 47
- Configuring the library 48
- Checking firmware level 51
- Configuring library settings 52
- Physical library settings 53
- Configuring network settings 54
- Managing user access 61
- Taking the Library Online 67
- Chapter 4. Operations 69
- The Operator Panel 71
- Monitoring the library 71
- View Current Information 72
- View Firmware Revision 72
- Unlock I/O Station 72
- UnlockMagazine 73
- Moving cartridges 74
- Unloading the drive 74
- Cleaning the drive manually 74
- Powering down the library 75
- Shipping the library 75
- Commands 76
- Reboot Drive 76
- Reboot Library 76
- Configuration 79
- Configure Library 79
- Configure Date/Time 79
- Set Date 79
- Set Time 79
- Chapter 4. Operations 4-13 81
- Chapter 4. Operations 4-15 83
- The Web User Interface 84
- The library map 86
- Chapter 4. Operations 4-19 87
- Managing the library 88
- Magazine state: Locked 90
- Chapter 4. Operations 4-25 93
- Chapter 4. Operations 4-27 95
- Chapter 4. Operations 4-29 97
- Chapter 4. Operations 4-31 99
- Chapter 4. Operations 4-33 101
- Servicing the library 102
- Library logs 103
- Trace data 104
- Downloading drive logs 104
- Downloading library logs 105
- Accessor statistics 107
- Chapter 5. Media 109
- Data cartridges 110
- Cartridge compatibility 111
- WORM media 111
- Data security on WORM media 112
- WORM media errors 112
- Cleaning cartridge 112
- Bar code labels 113
- TO1 2 3 L6 114
- Cartridge care and handling 115
- Provide training 115
- Ensure proper packaging 116
- Perform a thorough inspection 117
- Chapter 6. Troubleshooting 119
- Library error message content 120
- Diagnosing a problem 121
- Isolating problems 124
- Interpreting front panel LEDs 126
- Reseating cables 128
- Emailing logs 128
- Chapter 7. Service procedures 129
- Required tools 131
- Appendix A. Error codes 133
- Appendix A. Error codes A-3 135
- Appendix A. Error codes A-5 137
- Appendix A. Error codes A-7 139
- Appendix A. Error codes A-9 141
- Drive error codes 143
- Appendix A. Error codes A-13 145
- Trap definitions (types) 146
- Appendix B. TapeAlert flags 147
- Appendix C. Sense data 153
- Tape drive sense data 155
- Appendix C. Sense data C-5 157
- Appendix C. Sense data C-7 159
- Appendix C. Sense data C-9 161
- Physical Library 163
- Logical Library 163
- Tape Drive 163
- Network Settings 163
- Library and Drive Firmware 164
- Users Accounts 164
- Support Notification 165
- Accessibility 167
- Glossary 169
- Glossary F-3 171
- Glossary F-5 173
- Glossary F-7 175
- Glossary F-9 177
- Glossary F-11 179
- Glossary F-13 181
- Glossary F-15 183
- Glossary F-17 185
- Glossary F-19 187
- Printed in USA 194
Related products and manuals for Tape auto loaders & libraries Dell TL1000
(277 pages)© 2020, manymanuals.com. All rights reserved. | 1.822 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals